Correct maintenance of glass edging machine
Glass edging machine is an important equipment for deep processing of glass. In order to extend the service life of the machine, it is especially important to maintain the correct maintenance machine.
1. When using the water tank to supply circulating water, please replace the processing water after processing every day to avoid the water pipe blockage caused by dirt in the water tank.
2. When changing the water, please unplug the power plug, then take out the water tank, drain the waste water, and clean the dust in the water tank and the filter net.
Third, clean the spout, once the spout is blocked, the water volume is reduced or waterless, resulting in reduced processing capacity or even no work. When cleaning the spout, remove the nozzle and use a fine needle to remove the blockage inside the nozzle.
4. Clean the waterproof cover of the edging machine. If it is working for a long time, the cutting dust of the lens will adhere to the waterproof cover. If it is not cleaned in time, the cutting dust will solidify and it is difficult to remove. Thereby affecting the viewing line of sight. After the daily processing, please use a brush and a water spray container to clean.
5. Clean the edging chamber and process it for a long time, which will cause the cutting dust to be attached to the clip shaft, the chuck and the inner wall of the edging. If it is not removed in time, the lens will be scratched, and the shaft seal of the clip will be worn to cause the machine head. Into the water. There are two cleaning methods:
(1) Wash directly with a brush and a water spray container.
(2) Enter the machine cleaning mode to clean. This method also cleans the internal water supply line of the machine.
6. Clean the edging machine and the scanner housing. After using the machine every day, it must be cleaned immediately. If it is washed after a few days, the cutting powder will solidify on the casing and it will be difficult to remove. Clean the case with a soft cloth dampened with a mild detergent.
7. Trimming the grinding wheel. When the grinding wheel is blunt, the processing time becomes longer. In order to restore the performance of the grinding wheel, it should be repaired in time (after grinding about 1000 pieces of glass).
Cordless Curling Iron,Beauty Hair Curler,On Move Hair Curling Iron,Womens Fashion Curler Iron
CIXI BAOFANLY ELECTRICAL CO.,LTD , https://www.cnbaofanly.com